• 09.25.2014
  • Jimmy Finch

Technical Bulletin: G2.8 Injector Wire Guide

APTB 04/14

September 23,2014

Since February 2, 2010, Alliant Power has been laser etching the injector part number on the nozzle nut of G2.8 Injectors for easy and proper identification. As of September 23, 2014, the laser etched part number on the nozzle nut will be the only unique identifier to distinguish between G2.8 Injector part numbers. The wire guide and wire tie will no longer be unique to a specific G2.8 Injector part number. The images below show the array of wire guide colors that may be found on Alliant Power G2.8 Injectors. Alliant Power Technical Bulletin APTB 03/06 R1 has also been updated to
reflect these changes.

Jimmy Finch

Dallas Branch Manager, M&D Distributors

Jimmy Finch has over 33 years of experience in Diesel Engine Sales, Service and Repair. His experience started early in life at Texas Fuel Injection Service (an early acquisition of M&D) as a job with a means to an end. Somewhere in that 33 years this job turned into a fulfilling career. He started in the injector clean up department and has held practically every position leading up to his current role as Branch Manager of the Dallas, Texas location.

In his spare time, Jimmy enjoys spending time with his wife of 24 years, Priscilla. They are currently getting ready to make their way into the empty-nesters stage of life. He also enjoys the occasional hunting trip with friends and family and chasing down potential customers by the names off their trucks.

No Comment.

By posting a comment, you acknowledge and agree to M&D's terms and conditions.

Related Posts

  • Cummins Technical Service Bulletin TSB110277 Subject Signature™, QSX, and ISX CM570/CM870/CM871/CM2250 Replacement Cylinder Liner Compatibility Issue In January of 2010, a new cylinder block and cylinder liner were introduced for production and service for all 15 liter engines. The new…
  • Technical Bulletin: High-Pressure Oil System Leak Test October 7, 2014 The majority of Alliant Power AP63661 Remanufactured High-Pressure Oil Pumps (HPOP) returned for warranty consideration are found to be in good working condition with no faults detected. Properly troubleshooting injection control pressure…
  • Stanadyne Service Bulletin 398R1 Supersedes Bulletin 398 dated 03/15/1984 Housing Pressure Regulator Fittings The housing pressure return line connectors currently used in “D” series pumps are listed in the following chart. The operating pressure for each regulator fitting, the…

Diesel Engine Parts

for Your Diesel Engine's Needs

Shop Now